The string trimmer is a tool designed for garden maintenance and small grasses. It operates using nylon threads that make it up. Indeed, these threads, through their rotation, cut through herbaceous stems like a blade. However, the threads can break after several uses. It is then necessary to replace them. Discover here some ideas for loading the line of a string trimmer.
Disassemble the cutting head of the string trimmer
To load the line of a string trimmer, you must first start by disassembling the head of your string trimmer. To do this, you need to unplug your device if it is electric or remove its battery if it is a non-electric string trimmer. In the case of a gas trimmer, you simply need to turn off the engine and remove the battery to prevent accidents. Once this step is completed, you must remove the spool of line while unscrewing the closure collar of the cutting head.
Recommended read : How to Stay Fit Without Going to the Gym
You must carefully keep the spring located under the push button. Then, remove the ring with two slots that are diametrically opposite. This is what holds the spool of line. You can click on how to load the line of a string trimmer for more info.
Reload the line spool
After disassembling your string trimmer, it is important to reload the line spool. This reload must be done according to the model of your trimmer. Thus, you can prepare a line of about six meters, bent in the middle like a hairpin, equipped with two exits, two lines of 3 m each or a line with a single exit. Once the line is ready, you can begin your reload.
Related reading : How to Properly Maintain Your Garden with a Hedge Trimmer?
You need to wind the line(s) in the same direction as the arrow, making close coils. Leave a few centimeters of line and insert the ends into the two opposite openings of the flexible ring. You can now pull the lines through the holes provided for this purpose in the closure collar and reposition the ring to tighten the spool. Finally, replace the closure collar in its place, remembering to put the spring back.
Test the new line of the string trimmer
After everything has been replaced, you need to test the operation of the new line. To do this, press the push button while tapping the cutting head on the ground. Continue this action until the line is automatically cut to the correct length. You can then plug your device back in, replace the battery or spark plug, and operate it.